Maintenance; Disposal - Roger Technology B71/BCHP Serie Instrucciones Y Advertencias Para El Instalador

8

Maintenance

Perform a scheduled maintenance once every
6 months making sure that they are clean and
operational.
If there are any signs of dirt, moisture, insects or
other, cut off the power, disconnect the battery
and clean the board and the support. Run again the
Testing procedure.
If there is oxide on the printed circuit evaluate the
replacement.
Check the battery charger performing a complete
maneuvre and measure the voltage at its terminals:
a battery in good charging condition should maintain
a minimum voltage of 22Vdc. If the yellow DL1 LED
does not turn off even after days of charging, take
into consideration to replace the battery.
To achieve the best performance we recommend
you replace the batteries every 3 years.
9

Disposal

The product should always be uninstalled by qualified
personnel using the appropriate procedures for the
proper removal of the product.
This product is made of various kinds of materials,
some of them can be recycled, others must be
disposed of through recycling or disposal systems
according to the local regulations concerning this
category of product.
You should not dispose of this product using normal
recycle bins. Perform the "separate collection" for
disposal in accordance with the methods specified
by local regulations; or return the product to the
retailer when buying an equivalent new product.
Local regulations may imply heavy penalties for
illegal disposal of this product.
Warning: some parts of the product may
contain pollutants or toxic substances
that if disposed of, could cause harmful
effects on the environment and human
health.
7