Introduction To Instructions And Warnings; Danger Of Electric Shock; Technical Features - Roger Technology B71/BCHP Serie Instrucciones Y Advertencias Para El Instalador

CONTENTS
1 Introduction to instructions and warnings
2 Technical features
3 Product description
4 Description of connections
5 Fuses and warning LEDs
6 Operating mode
7 Testing
8 Maintenance
9 Disposal
10 Figures and diagrams
1
Introduction to instructions and
warnings
This manual is intended only for qualified technical
staff in charge with the machine installation.
The informations in this Manual are not intended
for the final user.
This manual refers to battery chargers of
B71/BC/INT included on the kit AG/BAT/KIT,
B71/BCHP/EXT and B71/BCHP/BOX and should not
be used for other devices.
DANGER OF
WARNINGS
ELECTRIC SHOCK
Carefully read this section before installing the
device.
2

Technical features

SUPPLY VOLTAGE:
MAXIMUM INPUT POWER
LEAD-ACID BATTERIES - (AG/BAT/KIT e B71/BCHP/EXT)
NOMINAL CHARGE VOLTAGE
MINIMUM SELF-PROTECTION VOLTAGE OF BATTERY
CHARGE CURRENT
OPERATING TEMPERATURE
PROTECTION RATING
PRODUCT SIZE CONTROL UNIT (B71/BCHP)
PRODUCT SIZE BATTERY BOX (BAT/BOX)
Page In order to prevent the risk of electrocution and
injuries, before performing any intervention on
5
the device, please cut off the power supply and
5
one of the two battery poles. To prevent the risk of
6
burning, be careful to avoid generating short circuits
6
on battery terminals by contact with braces or rings.
6
The machine must be installed only by qualified
6
staff, following the standards in force.
6
Perform the connections using appropriate cables
7
for the required current and voltage, respecting the
7
technical features of the product.
When installing cable glands (or fittings) on plastic
20
containers, secure them tightely to prevent water
from entering the box.
However, responsible to check that the connectin
is correct.
In the event of reversed connection, the red
LED "DL2" turns on and the circuit enters in
thermal protection mode: disconnect the battery
immediately and execute the connection correctly.
Please keep in mind that in the absence of voltage,
but with the batteries connected, the control unit
are under voltage.
36Vac
15W
2 x 12Vdc 4500mAh, connected in series
27.6 Vdc
19.5 Vdc
400 mA
-20°C ... +55°C
IP00
mm. 83x52x18 Weight: 38g
mm. 320x230x120 Weight: 4,8Kg
EN
5