Testing; Maintenance; Disposal - Roger Technology AG/CTRL AGILIK Instrucciones Y Advertencias Para El Instalador

11

Testing

Check the response to all the connected commands.
Check the stroke and the decelerations.
Check the forces of impact.
Check the way in which the safety devices intervene.
If any crushing occurs, make sure to be far away
from the limit switch or any obstacles that increase
the risk of crushing.
12

Maintenance

Perform a scheduled maintenance once every
6 months making sure that they are clean and
operational.
If there are any signs of dirt, moisture, insects or
other, cut off the power, disconnect the battery
and clean the board and the support. Run again the
Testing procedure.
If there is oxide on the printed circuit evaluate the
replacement.
13

Disposal

The product should always be uninstalled by qualified
personnel using the appropriate procedures for the
proper removal of the product.
This product is made of various kinds of materials,
some of them can be recycled, others must be
disposed of through recycling or disposal systems
according to the local regulations concerning this
category of product.
You should not dispose of this product using normal
recycle bins. Perform the "separate collection" for
disposal in accordance with the methods specified
by local regulations; or return the product to the
retailer when buying an equivalent new product.
Local regulations may set heavy penalties for illegal
disposal of this product.
Warning: Some parts of the product
may contain pollutants
substances; if disposed of, could cause
harmful effects on the environment and
human health.
or toxic
39