OHAUS i-DT61XWE Manual De Instrucciones página 6

EN-4
7. Connect the cable to the connectors on the Ethernet board.
8. Pull in the bottom of the indicator. Re-install the 4 screws (Torque is
1.8N*m±0.5). Fasten the cap nut of cable gland.
SETUP
Upon installation, the indicator will recognize the Ethernet interface kit and add
related items to the menu. Configure the indicator to the desired RS232 and
printing parameters (refer to the indicator's instruction manual for assistance).
Ethernet Connection
If DHCP is set to be ON, the IP share or router will automatically assign IP Address.
If the DHCP is set to be OFF, users need to setup the IP Address, Subnet Mask,
Gateway, Primary DNS and Secondary DNS. The Interface has a preset IP
Address. The Port Number is always 9761 and cannot be changed.
Note: After the setup of the IP Address, Gateway, Preferred DNS and Alternate
DNS, please reboot the indicator to enable the setting.
OPERATION
Output
With the interface installed, the indicator will operate in one of the following two
ways:
Auto Print = OFF, Stable = ON or OFF

Press PRINT will send the display data.
If Stable is set to be ON, the indicator will wait for a stable reading before
sending the stable data.
Auto Print = ON, Stable = ON or OFF

The indicator will automatically send data based on the settings in the menu.
If Stable is set to be ON, only stable values will be sent.
Data sent from the Interface is in standard ASCII format terminated with a [
(carriage return-line feed). For the output format, please refer to the indicator's
instruction manual.
CRLF
]