Configuration - OHAUS i-DT61XWE Manual De Instrucciones

Input
The indicator will respond to various commands sent via the interface adapter.
Terminate commands with [
Commands
For the full list of commands, please refer to the indicator's instruction manual.

CONFIGURATION

The Ethernet option board is connected to the i-DT61XWE indicator through the
RS232 interface. The baud rate is 19200.
If the option board is not connected, the submenu will not display. All the setting
parameters will be set through the OHAUS ScaleMate software. You can contact
an OHAUS authorized dealer for the software.
Reset
IP Address
Alt Print CMD
Ethernet
Alt Tare CMD
Alt Zero CMD
End
For printing template setup, please refer to the following table
Reset
Assignment
Print
Mode [Auto On Stable]
Setup
Time [Interval(seconds)]
Select Template
End Print3
CRLF
].
no, yes
192.168.1.1-9761
A~Z, P
A~Z, T
A~Z, Z
\
Stable Weight Only
[Demand]
Checksum [MT-
Continuous]
no, yes
Demand, Auto On Stable, Auto On
Accept, Interval (seconds), MT-
Continuous, OH-Continuous, SICS
Off, On (LFT is forced to be On)
Load, Load and Zero
1~50000
On/Off
Simple, Custom 1, Custom 2,
Custom 3, Custom 4, Custom 5
\
EN-5