Automatic Shutdown Function; To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna 120iTK4-H Manual De Usuario

• Hold the product near your body for a stable work
position.
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the cutting attachment
The cutting attachment can be adjusted in 7 different
positions.
1. Stop the product and remove the battery.
A
2. Hold the housing (B) tight.
3. Push and hold the lock buttons (A) at the 2 sides of
the housing (B).
4. Move the cutting attachment to the correct angle.
5. Release the lock buttons (A) at the 2 sides.
6. Move the housing (B) up and down until the cutting
attachment locks in position.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
1637 - 003 - 06.04.2021
B

Maintenance

Read and understand the
To start the Boost function
The product has a Boost function. The Boost function
gives stronger power.
1. Push the Boost button. The LED comes on to show
that the function is on.
2. Push the Boost button again to stop the Boost
function.

Automatic shutdown function

The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
60 seconds.

To stop the product

1. Release the power trigger.
2. Push and hold the start/stop button until the green
LED goes off.
3. Remove the battery from the product. Push the 2
release buttons and pull out the battery.
WARNING:
you do maintenance on the product.

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product.
Remove the battery before
13