To Adjust The Balance Xb Harness (535Irxt) - Husqvarna 535iFR Manual Del Usuario

3. Remove the support flange (F) and the saw blade
(D) from the output shaft.
G
B
C
4. Remove the drive disc (B) from the output shaft.
To adjust the Balance XB harness
(535iRXT)
1. Put the harness on.
2. Push the 2 parts of the breastplate together as
shown in the illustration.
3. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
4. Tighten the chest strap below your left arm tightly.
The chest strap must be tight against your body.
609 - 003 - 11.12.2019
F
D
5. Adjust the shoulder strap until the weight is equal on
the 2 shoulders.
6. Adjust the height of the suspension point. For
forestry clearing, the correct height of the
suspension is approximately 10 cm below your hip.
Correct balance of the product on page 19 .
Refer to
7. Attach the battery carrier to the harness.
Note: It is possible to attach 1 extra battery to the
battery carrier. The battery carrier is available as an
accessory.
8. Attach a battery.
To adjust the harness (535iFR,
535iRX)
WARNING: Always attach this product to the
harness correctly. If not, you cannot control
the product safely and this can result in
injury to you or others. Do not use a harness
with a defective quick release.
17