To Operate The Product; Throttle Control; To Use The Throttle Control; To Use The Heated Handles - Husqvarna ST 424 Manual Del Usuario

To operate the product

CAUTION: Do not partially engage drive
or auger levers for an extended period of
time; this can lead to premature wear or
burning of the belts.
Note: When both the drive engagement and auger
engagement are engaged, the drive engagement will
lock the auger engagement in position. Use the right
hand to control the snow discharge chute.
1. To engage the auger blades, push the auger
engagement (A) to the handle to engage the
auger and throw snow.
2. Raise the drive speed control lever (C) from the
middle position to make the product move
forward when the drive engagement (B) is
engaged.
3. Lower the drive speed control lever from the
middle position to make the product move
rearward when the drive engagement is
engaged.
B
4. To make the product move in the selected
direction, hold the drive engagement against the
handle .
5. If the product has power steering, hold the left
steering trigger (D) to turn left. Hold the right
steering trigger to turn right.
876 - 007 - 08.01.2020
A
C

Throttle control

Note: If the snow is wet or heavy, use the fast or
boost modes.
The throttle control adjusts the engine speed. It has
3 modes: boost, fast and slow.
A B
• Boost (A): to increase speed when the product is
operated but does not throw snow, or to increase
the distance that snow is thrown.
• Fast (B): standard operation
• Slow (C): to decrease the distance that snow is
thrown, or to decrease engine noise

To use the throttle control

• Turn the throttle control to change the engine
speed.

To use the heated handles

• Push the switch to I to start the heated handles.
• Push the switch to O to stop the heated handles.
D
C
13