To Stop The Product; To Adjust The Skid Plates; To Adjust The Discharge Chute And The Discharge Chute Deflector; To Use The Drift Cutters (If Equipped) - Husqvarna ST 424 Manual Del Usuario

To stop the product

1. Turn the key to the STOP position.
2. Remove the ON/OFF key.
To adjust the discharge chute and
the discharge chute deflector
1. Push the release lever (B) on the discharge
chute lever (A) and adjust the discharge chute to
the left or right position.
2. Move the remote control lever (C) to adjust the
snow throwing distance.
a) Move the remote control lever up to decrease
the snow throwing distance.
b) Move the remote control lever down to
increase the snow throwing distance.
14
A
B
C

To adjust the skid plates

The skid plates prevent damage to the bottom of the
snow thrower. Adjust the skid plates (A) when the
locknut (B) is loose, or the skid plate is not at the
correct distance from the ground. No adjustment is
necessary for standard installation.
1. Loosen the locknut (B) with a 13 mm (½ in.) open
wrench.
2. Move the skid plates (A) up or down.
a) On flat surfaces set the distance between the
scraper bar and the ground to 5-6 mm
(0.2-0.25 in).
b) On rough surfaces set the skid plates (A) in a
position where the scraper bar is above the
top of the ground.
WARNING: Make sure that
gravel and stones do not go into
the product. Objects that eject at
high speed can cause injury.
3. Tighten the locknut (B).

To use the drift cutters (if equipped)

Use the drift cutters to cut through snowdrifts deeper
than the front of the product.
1. Loosen the adjustment nuts (A) on both sides of
the product to allow each drift cutter (B) to be
raised to its highest position.
A
B
876 - 007 - 08.01.2020