Tools Required; To Install The Handle; To Install The Discharge Chute - Husqvarna ST 424 Manual Del Usuario

Spring (1)
Shoulder bolt ¼-20 (1)

Tools required

• 3/8 in. wrench (1)
• 7/16 in. wrench (1)
• 1/2 in. wrench (1)
• 9/16 in. deep socket (1)

To install the handle

1. Lift the upper handle to the operation position.
2. Adjust the handle position to one of the holes
(C).
876 - 007 - 08.01.2020
A
C
3. Put the bolt (B) through the hole (C).
4. Attach the knob (A) to the bolt and tighten the
knob.
5. Attach more carriage bolts (B) and handle knobs
(A) to attach the upper handle to the lower
handle.

To install the discharge chute

1. Put the deflector assembly for the discharge
chute on the top of the discharge chute. The
discharge opening must point to the front of the
product.
2. Put the rotator head (A) on the discharge chute
bracket (J).
3. Align the pins below the rotator head with the
holes in the discharge chute bracket.
4. Put the rotator head on the pin (E), and the
threaded stud (G) on the bracket (E).
B
9