To Remove The Product From The Carton; Loose Parts; Assembly - Husqvarna ST 424 Manual Del Usuario

• Before you do the maintenance on the product,
stop the engine and remove the ignition cable
from the spark plug.
• Use protective gloves when you do maintenance
on the blades. The blades are very sharp and
cuts can easily occur.
• Accessories and changes to the product that are
not approved by the manufacturer, can cause
serious injury or death. Do not change the
product. Always use accessories that are
approved by the manufacturer.
To remove the product from the
carton
1. Remove loose parts included with the product.
Cut the four corners of the carton and put the
end panels down flat.
2. Remove the two screws that attach the auger
housing to the pallet. Remove the steel brackets
from the skid plates if they have it.
3. Remove all package materials.
4. Remove the product from the carton and make
sure no loose parts are left in the carton.

Loose parts

Discharge chute (1)
ON/OFF key (s)
Carriage bolts 5/16-18 x 2 ¼" (2)
Chute retainer
Handle knobs (2)
Locknut 3/8 (1)
Locknut 3/18-16 (1)
8
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this
operator's manual. All other servicing must be
done by an approved service agent.
• Let an approved service agent do servicing on
the product regularly.
• Replace damaged, worn or broken parts.

Assembly

(ST 424/427/430 ) Cable holder (1)
Shear pins ¼-20 x 1.81 (6)
Locknuts ¼-20 (6)
Locknut 5/16-18 (1)
Locknut ¼-20 (1)
Nylon washer (1)
Carriage bolt 5/16-18 x 5/8 (1)
Roll pin (1)
Release lever (1)
Discharge chute lever
876 - 007 - 08.01.2020