Mains Connection - IKRA HHSI 5551 Manual Original

MAINS CONNECTION

DANGER
Appliances used at many different locations including
wet room and open air must be connected via a residual
current device (FI, RCD, PRCD) of 30mA or less.
Before use check machine, cable, and plug for any dama-
ges or material fatigue. Repairs should only be carried out
by authorised Service Agents.
Insert the plug of the electrical cable in a socket of suitable
shape, voltage and frequency complying with current
regulations.
Keep the connection and extension cables away from
dangerous moving parts to avoid damaging them.
Only use splash proof extension cables approved for
outdoor purposes. The stranded wire cross-sectional area
of the extension cable must be at least 1.5 mm
up to 25 m and 2.5 mm for cables above 25 m.
2
Make sure the machine is switched off before plugging in.
The device is only intended for use on premises that have
a continuous current carrying capacity of >=100 A per
phase and are supplied from a electrical grid with a rated
MAINTENANCE
DANGER
Before doing any work on the device pull the plug out of
the socket. Wait until all rotating parts have stopped and
the appliance has cooled down.
Keep the device, in particular the air vents, clean at all
times. Never spray water on the device body! Never clean
the machine and its components with solvents, flammable
or toxic liquids. Us only a damp cloth making.
Use only original accessories and original spare parts.
Components for which there are no instructions for
exchanging should be replaced by the manufacturer only.
DISPOSAL
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
voltage of 400/230V.
If necessary, please consult your electricity company to
ensure that the continuous current carrying capacity of
the mains at the connection point is sufficient for connec-
ting the device.
WARNING
WARNING! Electric shock! There is a risk of an injury
caused by electric shock!
Do not use the device if the cable or plug is damaged or
worn.
If the cable is damaged during use, it must be discon-
nected from the mains supply immediately. Do not touch
the cable until it has been disconnected from the mains.
Do not connect a damaged cable to the power supply
and do not touch a damaged cable before disconnecting
it from the power supply, as damaged cables can lead to
for cables
2
contact with active parts.
If the replacement of the supply cord is necessary, this has
to be done by the manufacturer or his agent in order to
avoid a safety hazard.
Using other spare parts can result in accidents/injuries of
the user. The manufacturer will not be liable for any such
damage.
Please contact our service department if you need acces-
sories or spare parts.
Only a regularly maintained and treated appliance can
serve as a satisfactory aid. Insufficient maintenance and
care can lead to unforeseen accidents and injuries.
Repairs and works specified in these Instructions may only
be performed by qualified authorised staff.
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning
the disposal of materials and devices are available from
your local administration.
GB ENGLISH
15