Install The Mounting Brackets And Pulley Assemblies - Kohler K-1913 Guia De Instalacion

Ocultar thumbs Ver también para K-1913:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Install Mounting Brackets

13. Install the Mounting Brackets and Pulley Assemblies

Installations Requiring Disassembly Only
NOTE: These steps are not required if the mounting brackets and pulley assemblies were not removed in
a previous step. If the mounting brackets and pulley assemblies were not removed, proceed to the "Install
the Door" section.
Install the Mounting Brackets
Align a mounting bracket with the holes in the bath.
Use the four previously removed blue screws to secure the mounting bracket to the bath.
Adjust the mounting bracket so it is centered in the slots or out as far as the slots allow.
Tighten the screws.
Repeat with the second mounting bracket.
1128532-2-H
Slot
Mounting
Bracket
Blue
Screw
24
Install Pulley Assemblies
Red
Screw
Limit Switch Wires
Slot
Pulley
Assembly
Kohler Co.

Publicidad

Tabla de contenido
loading

Tabla de contenido