Heated Surface Electrical Connections (If Equipped) - Kohler K-1913 Guia De Instalacion

19. Heated Surface Electrical Connections (if equipped)

WARNING: Risk of electric shock. Connect the power supply to a properly grounded,
grounding-type receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual
Current Device (RCD). Do not remove the plug grounding pin. Do not use a grounding adapter.
The heated surface feature is equipped with a cord and plug. The power supply has been wired at
the factory. A qualified electrician must install a GFCI-protected, 120 V, 15 A, grounded outlet.
Locate the outlet behind the bath and within 24" (610 mm) of the power supply.
Plug the power supply into this outlet.
Test the Heated Surface Feature
Check all electrical connections and make sure the electrical power to the bath is on.
Operate the heated surface user keypad to test the temperature settings.
1128532-2-H
Heating Surface
GFCI-Protected Receptacle
Power Supply
34 Kohler Co.