Publicidad
T-Connector end into the vehicle connector, pressing firmly
to ensure the locking tabs engage.
Caution: Take care not to damage the locking tabs.
5. Locate the existing ground stud near the how harness
connector. Using a 10mm socket, secure the T-connector's
White wire to the ground stud.
6. Open the vehicle vehicle's hood and locate the fuse/
relay panel on the left (driver's) side near the firewall (Fig. 3).
7. Using the fuse panel diagram on the underside of the
panel cover, locate relay positions #58 and #59. Insert the
two relays (provided) into these positions.
8. Again using the fuse panel diagram, locate fuse
positions #35, #37 and #43. Place the three 10 amp ATM
fuses into these positions.
Caution do not replace fuses or relay with higher
rated devices than those provided.
9. Test the installation using a test light or properly
equipped trailer.
10.Return all trim panels and covers to their original
positions. Store the T-Connector's 4-flat end in the jack
storage compartment when not in use.
Publicidad
