Battery Replacement - GYS STARTPACK TRUCK Manual Del Usuario

Translation of the original instructions
STARTPACK TRUCK & STARTPACK TRUCK MOBILE

BATTERY REPLACEMENT

Regardless of the type of STARTPACK TRUCK (standard or mobile) and its use mode (12V or 24V),
always replace both batteries at the same time.
Startpack Truck standard et mobile
-
1
STARTPACK TRUCK
STARTPACK TRUCK
Whichever mode the STARTPACK TRUCK is being used for (12V or 24V), replace both batteries at the
same time.
To replace the batteries :
• First the back panel must be unscrewed (18 screws) and removed.
• Once the back panel has been removed, the batteries are visible, with one in front of the other (see picture). -
terminal on the left, + terminal on the right.
• The battery is connected to the STARTPACK at two points : at the - terminal and at the + terminal. To remove
the battery, remove the screws (see pictures 1 and - 2 ) that enable the connection between the battery and
the STARTPACK TRUCK at the terminals + and -. (Once the first battery is removed, it is possible to remove the
second one from the machine's end)
Once the first battery is removed, make sure to insulate the terminals to prevent any
short circuit. Then remove the second battery.
When setting up the new battery the new batteries,
polarities of both the batteries and the STARTPACK TRUCK. - Terminal on the left, +
terminal on the right (see picture). Put the 4 screws and washers back on, tighten the
nuts (recommended tightening torque of 4 Nm).
• Once the batteries are replaced, proceed in reverse order of the above operations in order to recover the booster.
16
Battery Type
6FM - 22 Lead acid battery
Voltage (V) Capacity (Ah)
2 x 12 2 x 22
make sure to associate the
EN
+
2
Batteries
dimension Battery ref
(mm)
38,9 x 22,5 x 50 53151