Maintenance 535Rbx - Husqvarna 535FBX Manual Del Usuario

Ocultar thumbs Ver también para 535FBX:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To stop the product
1. Move the stop switch into the stop position to stop
the engine.
CAUTION: The stop switch automatically
goes back to its initial position. In order
to prevent accidental starting, the spark
plug cap must be removed from the
spark plug when assembling, checking
and/or maintenance is done.
Forestry clearing
General work instructions
WARNING: Be careful when you cut a tree
that is in tension. The tree can move quickly
before or after you cut it. Keep a correct
position and operating procedure to prevent
serious injury.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
Maintenance schedule
The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
described later in this chapter.
Maintenance
Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the saw chain does not rotate at idle speed.
Clean the air filter. Replace if necessary.
Check the saw chain with regard to visible cracks in the rivets and links, whether
the saw chain is stiff or whether the rivets and links are abnormally worn.
Clean the area under the protective cover.
Make sure that the screws and nuts are tight.
1301 - 003 - 20.11.2019

Maintenance 535RBX

Note: The user must only carry out the maintenance and
service work described in this operator's manual. More
extensive work must be carried out by an authorized
service workshop.
Clear an open space at one end of the work area,
and start the work from there.
Move in a regular pattern across the work area.
Move the product fully to the left and right, to clear a
width of 4–5 m on each turn.
Clear a length of 75 m before you turn and go back.
Move the fuel can along with you as you continue.
Move in a direction where you do not go across
ditches and obstacles more than necessary.
Move in a direction where the wind makes the cut
vegetation fall in the cleared area.
Move along slopes, not up and down.
Daily
X
X
X
X
X
X
X
X
Weekly
Monthly
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ta1100

Tabla de contenido