Husqvarna 535FBX Manual Del Usuario página 8

4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
5. Start the product (refer to instructions under
the product on page 18 ) and apply full throttle.
6. Release the throttle and make sure that the saw
chain stops and remains at a standstill. If the saw
chain rotates with the throttle in the idle position the
carburettor idle setting must be checked. Refer to
instructions under the chapter
speed on page 20 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the vibration damping system
The vibration damping system of the product decreases
the vibration between the engine unit and the shaft unit
of the product. This keeps the vibration in the handles to
a minimum which makes the operation easier.
1. Stop the engine.
8
To start
To adjust the idle
2. Do a visual check for deformation and damage, for
example cracks.
3. Make sure that the elements of the vibration
damping systems is attached correctly.
To do a check of the muffler
WARNING: Bear in mind that the exhaust
fumes from the engine are hot and may
contain sparks which can start a fire. Never
start the product indoors or near
combustible material!
WARNING: Never use the machine indoors
or in spaces lacking proper ventilation.
Exhaust fumes contain carbon monoxide, an
odourless, poisonous and highly dangerous
gas.
WARNING: Never use a product with a
faulty muffler.
The muffler keeps noise levels to a minimum and sends
exhaust fumes away from the operator. For mufflers it is
very important that you follow the instructions on how to
check, maintain and service your product.
1301 - 003 - 20.11.2019