Using The Hand Brake; Adjusting Height - Invacare Value Serie Manual Del Usuario

USING THE HAND BRAKE

NOTE: For the following procedure, refer to FIGURE 1 on pages 8 and 9.
1. Pull up on the top portion of the brake handles towards the push handles.
2. Perform one of the following:
• Remain Stationary - Hold the brake handle up.
• Continue Mobility - Release the brake.
LOCKING BRAKES
MODELS 65410, 65450, 65650 AND 65850
Push down on the bottom portion of the brake handle.
MODEL 65750
Push down on both push handles.
UNLOCKING BRAKES
MODELS 65410, 65450, 65650 AND 65850
1. Pull up on the top portion of the brake handle.
2. Release the brake handle.
MODELS 65750
Lift up on both push handles.

ADJUSTING HEIGHT

NOTE: For the this procedure, refer to FIGURE 1 on pages 8 and 9.
MODELS 65410, 65650, 65750 AND 65850
1. Loosen and remove the adjustment knob by turning counterclockwise.
2. Position the push handle so that when the user's arm is down to their
side, the handgrip is at wrist height.
3. Install the adjustment knob into one of the six adjustment holes.
4. Secure the adjustment knob by turning clockwise.
5. Securely tighten.
6. Repeat STEPS 1-5 for the other side.
1134856B.pmd
6
6 4/28/2006, 4:25 PM