QSC PLD Serie Guide De Mise En Route Rapide página 3

Outputs
The PLD amplifiers have four configurable outputs. You can set power, combine outputs (bridged and parallel), and adjust the DSP for each one. The
output connections are enabled by relays, and they follow the configuration selected by the user. Use
loudspeakers.
Separate hannels (A B
Ap to four separate loudspeaker loads
Use up to four two-wire cables; connect to
• 1+/1- on outputs A through D as needed
Bi-amp operation
Use four-wire cables; connect to
• 1+/1- (CH A) and 2+/2- (CH B) on
output A
• 1+/1- (CH C) and 2+/2- (CH D) on
output C
Bridged (A+B) and Separate (
Bridged (A+B)
Use two-wire cable; connect to
• 1+/1- on output X
Separate & D
Use two-wire cables; connect to
• 1+/1- (CH C) on output C
• 1+/1- (CH D) on output D
Bi-amp and D
Use four-wire cable; connect to
• 1+/1- (CH C) and 2+/2- (CH D) on
output C
Parallel hannels (AB D)
Multiple parallel loudspeaker loads
Use up to four two-wire cables; connect to
• 1+/1- on outputs A through D as needed
Single loudspeaker load
Use two-wire cable; connect to
• 1+/1- on output A, B, C, or D
D)
— Figure 5 —
D) hannels
— Figure 6 —
— Figure 7 —
Figures 5
3
through 7 as references for wiring the
TD-000351-00-E
EN