QSC PLD Serie Guide De Mise En Route Rapide página 6

PLD Amplifier Signal Flow
Input Settings
1
Sensitivity
A/D
Switch
2
Sensitivity
A/D
Switch
3
Sensitivity
A/D
Switch
4
Sensitivity
A/D
Switch
EN
Menu Tree
Presets
Preset Recall
Preset Save
Preset Wizard
*For QSC line array loudspeakers only.
A Power On
After connecting the outputs to the loudspeakers, you may turn the amplifier on.
1. Make sure the outputs levels on all audio source devices (CD players, mixers, instruments, etc.) are all the way down.
2. Turn on all the audio sources.
3. Turn on the AC mains power switch on the back of the amplifier. The amplifier will resume the state it was in when power was removed. If the
amplifier is in Standby or Mute All mode (Power button LED solid red or blinking), press the Power button to change the amplifier into Run mode.
4. You can now raise up the output levels of the audio sources.
TD-000351-00-E
Source
Meter Gain Mute
Select
Source
Meter Gain Mute
Select
Source
Meter Gain Mute
Select
Source
Meter Gain Mute
Select
Button
Activated
Inputs
Input Sensitivity
Input Gain
Output Processing
High-pass Low-pass 5-Band
Gain /
Filter Filter PEQ
Polarity
High-pass Low-pass 5-Band
Gain /
Filter Polarity Filter PEQ
High-pass Gain / Low-pass 5-Band
Filter Filter PEQ
Polarity
High-pass Low-pass 5-Band
Gain /
Filter Polarity Filter PEQ
Crossover
— Figure 11 —
Outputs
Source Select
Spkr Processing
Crossover
PEQ
Delay
Limiter
Array Correction*
Load Speaker
Save Speaker
6
Amp Config.
RMS / Peak
A
Delay D / A
Limiter
RMS / Peak
B
Delay D / A
Limiter
RMS / Peak
C
Delay D / A
Limiter
RMS / Peak
D
Delay D / A
Limiter
Set by Preset or Wizard
Atilities
Status
Amp ID
Display
Lockout
Password
GPI
GPO
A
Meter
B
Meter
C
D
Meter
X
Meter
Y