Attaching The Auxiliary Handle; Attaching And Replacing Roughing / Grinding / Cutting Discs; Operation; Switching On And Off - Parkside PWS 230 Instrucciones De Utilización Y De Seguridad

j Insert the disc cover guide
projection in the coded groove
9
j Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
j Close the clamping lever
the disc guard cover
If necessary the clamping force of the connection
can be adjusted by tightening or loosening the
adjuster screw .
10
Ensure that the disc guard cover
on the spindle collar.

Attaching the auxiliary handle

Q
m Caution! For safety reasons this device must
always be used with the auxiliary handle
place.
J
Pull the mains plug out of the mains socket be-
fore you carry out any task on the device.
j Screw the auxiliary handle
or on the top of the head of the device.
Attaching and replacing
Q
roughing / grinding / cutting discs
Take note of the dimensions of the roughing / grind-
ing or cutting discs. The circular hole must fit on to
the mounting flange without play. Do not use a re-
ducer piece or adapter.
J
Pull the mains plug out of the mains socket be-
fore you carry out any task on the device.
J
Check the condition of the roughing / grinding
or cutting discs. They must be free of damage,
moisture or cracks.
m Danger of burns! Always wear protective
gloves when changing a roughing / grinding or
cutting disc. Roughing / grinding and cutting
discs become hot during use. Do not touch
them until after they have cooled down.
j Note: Always ensure the discs are free of dirt
before use.
j Use only abrasive consumables or tools with
an allowable speed at least as high as the no-
with the coded
7
.
16
into the desired
7
must always be facing
7
to firmly clamp
8
in place.
7
sits firmly
7
6
on the left, right
6
Preparing for use / Operation
load speed of the device.
j Press the spindle lock button
mounting spindle
j Press the spindle lock button
drive.
j Release the clamping nut
, Fig. C.
17
j Place the roughing / grinding or cutting disc on
to the mounting flange
facing towards the device.
j Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
14
j Press the spindle lock button
drive.
j Tighten the clamping nut
spanner .
17
j Note: Replace a new disc immediately if it
in runs unevenly or vibrates after being exchanged.
j After replacing a disc let the device run under
no-load conditions for 30 seconds as a safety
check. Look out for unusual noises or generation
of sparks. Check that all the fastened-on parts
are correctly attached.
j Pay attention to see that the arrow showing the
direction of rotation on the roughing / grinding
or cutting discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).

Operation

Q

Switching on and off

Q
Note: Always switch on the angle grinder before
bringing it into contact with the workpiece material.
Switching on the device
j Press the safety lock-out
Then press the ON / OFF switch
Switching off the device
j Release the ON / OFF switch
only after the
11
has reached a standstill.
14
to block the
11
using the spanner
13
with its labelled side
15
, with its
13
to block the
11
again with the
13
.
3
2
.
2
GB/MT 37