Fitting The Additional Handle; Fitting/Changing The Roughing/Cutting Disc - Parkside PWSA 20-Li A1 Traducción Del Manual De Instrucciones Original

RISK OF INJURY
► Make sure that the blade guard
at least at the same angle as the additional
handle (see fig. B). Otherwise, you could
injure yourself on the roughing disc or cutting
disc.
♦ Open the clamping lever
♦ Place the blade guard
in the coding groove
♦ Turn the blade guard
(working position). The closed side of the blade
guard must always be toward the operator.
♦ Close the clamping lever
guard into position. If necessary, the clamping
force of the lock can be changed by loosening
or tightening the adjusting nut
the blade guard
spindle.

Fitting the additional handle

ATTENTION!
► For safety reasons, this appliance may only
be used with the additional handle
Failure to do this can lead to serious injury.
The additional handle
the left or the right depending on the job at
hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/rough grinding discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
mounting flange without any play. Do not use
a reducer or adapter.
NOTE
► Use only discs which are free of dirt.
│ GB │ IE
■ 30
is fitted
.
with the coding pin
.
to the required position
to clamp the blade
. Ensure that
sits firmly on the neck of the
.
can be screwed onto
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button only when the mounting spindle
at a complete standstill.
♦ Press the spindle locking button
motor.
♦ Undo the clamping nut
mounting spanner
♦ Place the rough grinding or cutting disc with
the label side towards the appliance on the
mounting flange
♦ Then replace the clamping nut
raised side facing up on the mounting spindle
With thin grinding discs (see fig. 1):
♦ The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
♦ Press the spindle locking button
motor.
♦ Tighten the clamping nut
mounting spanner
With thick grinding discs (see fig. 2):
Fig. 2
The collar of the clamping nut
so that the grinding disc can be fitted securely onto
the mounting spindle
to lock the
using the two-hole
(see fig D).
.
with the
faces upwards
≤ 3,2 mm
to lock the
using the two-hole
.
> 3,2 mm
faces downwards
.
PWSA 20-Li A1
is
.
12