IKOS ECOpellets 8 Manual Del Usuario página 90

Service
EN
Normal use of the stove
Start up
After fill the pellet thank (see section 11.2), to start the stove you need to press the ON/OFF
button for 3 seconds. The display should show "Ignição" (Ignition), until the ignition phase is
finished.
The pellets are transported trough the feeder to the burner in the combustion chamber were
they´ll be lightned by an ignitor. This process could take from 5 to 10 minutes, depending if
the pellet feeder screw is empty or previously loaded with pellets. After the ignition stage, the
display shoul perform "On" message.After the ignition fase is completed, the display should
show "On". The power level can be set at any moment by pressing the power selection button
for aprox 1 second. The user can choose from 5 diferent power levels. The selected power
level remaing visible in the display. The power level after the ignition stage is the last selected.
Before turning on the stove check if the baffle plate is placed correctly.
Turn Off
The "Off" order to the stove is sent by pressing the "On/Off" button for 3 seconds.
Until the shut down process is completed, the display will show "Desactivação" (Disabling) until
full completion of this phase. The extractor will operate until the fume temperature of 64°C is
reached, to guarantee that all the pellets were burned.
Turning off the unit
You should only switch off the appliance after you have completed the shutdown procedure,
make sure the display shows "Off". If necessary, disconnect the power supply.
Refilling the pellets tank
1. Open the pellet reservoir lid by sliding the lock sideways and lifting the lid.
2. Pour the pellets into the reservoir and close the pellet reservoir again.
2100 hours (T66)
maintenace hours
reached.
EN // 90
USER'S MANUAL
Contact your seller for maintenance.