Troubleshooting - JVC KW-AV71BT Manual De Instrucciones

Troubleshooting

What appears to be trouble is not always serious. Check the following points before calling a service center.
• For operations with the external components, refer also to the instructions supplied with the adapters used for the
connections (as well as the instructions supplied with the external components).
If the following messages appear
Message
"No Signal"
"MISWIRING Check wiring
connection then reset unit"
"WARNING Check wiring
connection then reset unit"
"Parking Brake"
"Eject Error" / "Loading Error"
"Restricted Device"
"USB Device Error"
"No BT Dongle"
"Connection Error"
"Please Wait..."
"No Voice Device"
"No Data"
"Initialize Error"
"Dial Error"
"Hung Up Error"
"Pick Up Error"
"Pairing Error"
• Start the playback on the external component connected to VIDEO IN jack.
• Check the cords and connections.
• Signal input is too weak.
A speaker cord has shorted or it has come in to contact with the car chassis.
Wire or insulate the speaker cord as appropriate, then reset the unit
(☞ page 3). See also the Installation/Connection Manual.
No playback picture is shown when the parking brake is not engaged.
Eject the disc forcibly. (☞ page 3)
Check whether the connected iPod/iPhone is compatible with this unit. (☞
page 29)
• The USB power voltage is abnormal.
• Turn off and turn on the unit.
• Connect another USB device.
The Bluetooth adapter (KS-UBT1) is removed.
The device is registered but the connection has failed. Connect the registered
device. (☞ page 53)
The unit is preparing to use the Bluetooth function. If the message does not
disappear, turn off and turn on the unit, then connect the device again (or reset
the unit).
The connected mobile phone does not have the voice recognition system.
No phone book data is contained in the connected Bluetooth phone.
The unit has failed to initialize the Bluetooth module. Try the operation again.
Dialing has failed. Try the operation again.
The call has not ended yet. Park your car, and use the connected mobile phone
to end the call.
The unit has failed to receive a call.
Pairing between the unit and Bluetooth device has failed. Register the device
again. (☞ page 52)
68
Remedy/Cause