Basic Settings; Changing Basic Settings; Overview Of The Basic Settings; Changing The Time - Siemens BF634.G.1 Manual De Usuario E Instrucciones De Montaje

10 Basic settings
You can configure the appliance to meet your needs.
10.1 Changing basic settings
Press ⁠ .
1.
Press ⁠ .
2.
a The operating modes menu opens.
Use the rotary selector to select "Settings".
3.
Press ⁠ .
4.
Use the rotary selector to change the values.
5.
Always use to switch to the next settings and, if re-
6.
quired, to make any changes.
Press ⁠ .
7.
a "Discard" or "Save" appears on the display.
Select "Save" to save the setting.
8.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
10.2 Overview of the basic settings
This is where you can find an overview of the basic set-
tings and factory settings. The basic settings depend
on the features of your appliance.
Notes
¡ Changes to the language, button tone and display
brightness settings take effect immediately. All other
settings do not take effect until you save them.
¡ Your changes to the basic settings will be retained
even after a power failure. Only the settings pertain-
ing to the initial start-up of the appliance need to be
implemented once again following a power failure.
→ "Initial use", Page 8
Basic settings Selection
Language Set "Language"
Time Set "Time "
Date Set "Date"
Factory setting (may vary according to model)
1
11 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
11.1 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Basic settings Selection
Audible signal Short cooking time
Medium cooking time
Long cooking time
Button tone Switched off
Switched on
Display bright- The display brightness can be adjus-
ness ted in 5 settings
Setting 3
Clock display Digital + date
Digital
1
Off
Night-time dim- Switched off
ming Switched on (display dimmed
between 10 p.m. and 6 a.m.)
Demo mode Switched off
Switched on (this is only displayed in
the first 3 minutes following a reset
or the initial start-up)
Factory set- Reset
tings Do not reset
1 Factory setting (may vary according to model)
Note: Changes to the language, button tone and dis-
play brightness settings take effect immediately. All
other settings do not take effect until you save them.
10.3 Changing the time
Press ⁠ .
1.
Press ⁠ .
2.
a The operating modes menu opens.
Use the rotary selector to select "Settings".
3.
Use to navigate to "Time ".
4.
Use the rotary selector to change the time.
5.
Press ⁠ .
6.
Select "Save" to save the setting.
7.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
New sponge cloths contain residues from production.
Wash new sponge cloths thoroughly before use.
▶
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
Basic settings en
1
1
1
1
1
1
13