Changing The Basic Settings; Basic Settings; Care And Cleaning; Cleaning Agents - Siemens HB84E562 Instrucciones De Uso

Changing the basic settings

Your appliance has various basic settings which you can
change at any time.

Basic settings

In the table, you will find all the basic settings and options for
changing them.
Basic setting
Clock display
™‚
= on
‚
Signal duration:
™ƒ
ƒ = medium = 2 minutes
Button tone:
™„
‚ = on
Waiting time:
™...
= medium = 5 seconds
ƒ
Signal volume:
™†
= medium
ƒ
Requirement: Your appliance is switched off.
Press and hold the button for several seconds.
0
1.
The first basic setting appears in the display.
Use the or button to change the basic setting.
@ A
2.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Unpleasant odours, e.g. after fish has been prepared, can be
■
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.
Options
Clock display
= off
ƒ
Signal duration:
‚ = short = 10 seconds
= long = 5 minutes
„
Button tone:
ƒ = off
Waiting time:
= short = 2 seconds
‚
„ = long = 10 seconds
Signal volume:
= low
‚
„ = high
Confirm by pressing the
3.
The next basic setting appears in the display. You can go
through all of the basic settings using the
make changes using the
When finished, press and hold the
4.
seconds.
All settings are applied.
You can change the settings at any time.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use:
any caustic or abrasive cleaning agents,
■
metal or glass scrapers to clean the glass in the appliance
■
door,
metal or glass scrapers to clean the door seal,
■
hard scouring pads and sponges,
■
cleaning agents with high concentrations of alcohol.
■
Rinse out new sponge cloths thoroughly before use.
For easier cleaning, you can switch on the oven light. Open the
appliance door to do so.
Area
Appliance front
Explanation
Displays the clock
Signal after the cooking time has elapsed
Confirmation tone when a button is pressed
Waiting time between two separate steps, after
setting
Volume of the signal
button.
0
@ or A button.
0
Cleaning agents
Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Do not use glass clean-
ers or metal or glass scrapers for clean-
ing.
button and
0
button for several
11