CASUALPLAY KUDU 4 Instrucciones página 24

Folding in the reverse position, with the seat facing backwards
(diagram 21)
• Fold the hood and put the backrest in the horizontal position.
• Slide the two catches on the sides of the handlebar.
• Push the handlebar forwards.
• Fold the rear part of the pushchair.
• Fasten the locking device (fig.20).
Fitting the rain cover (diagram 22)
WARNING: THIS RAIN COVER CAN NOT BE USED ON A PUSHCHAIR
THAT IS NOT FITTED WITH A HOOD.
• Unfold the hood.
• Place the rain cover on top of the Kudu 4, take care when fitting the rain cover.
• Fit the lower part of the cover to the footrest, and fasten the two Velcro strips to the front
part of the chassis.
Fitting the Unisystem adaptors (diagram 23)
WARNING: The adaptors can only be used in conjunction with one of the
complements: Prima, Prima Fix, Baby 0+, Newmoon, Metropol, Sono and
Nuno.
WARNING: the unisystem adaptors only have one correct position, do not try
to force the adaptors.
• Fit each of the adaptors into the corresponding unisystem side slots. When correctly
fastened a red signal will appear in the side window of each adaptor.
• To disconnect, press the red mark on each adaptor.
Unisystem (diagram 23-24)
This exclusive fastening system means that the following complements can be used on
the Kudu 4 pushchair:
Nuno
.
WARNING: INSTALL THE UNISYSTEM ADAPTORS BEFORE INSTALLING
ANY COMPLEMENT.
22
Prima, Prima Fix, Baby 0+, Newmoon, Metropol, Sono and