Parameter Settings; Configuration - BONFIGLIOLI Vectron ACU-P Serie Manual Del Usuario

5.5.

Parameter settings

The parameters displayed in the PARA menu branch are partly set via the guided commissioning.
Additional configurations with further parameter settings are described in the operating
instruction manual.
GB
D
05/ 2014
28 – The brief instructions describe the
Control Level
parameters in control level 1. The parameters of the higher
control levels are described in the operation instructions and
should be up by expert operators only.
Setting : 1-2-3
Default: 1
30 – The basic function of the control inputs and

Configuration

outputs as well as the assignment of the software modules is
selected by the configuration. The selection is made during the
guided commissioning.
Setting range: 110 sensor less control with U/f characteristic
700 synthetic network with preset reference
701 synthetic network with reference channel
34 – The factory settings of all parameters is
Program(ming)
restored or a fault message is acknowledged
(alternative to
Error Acknowledgment
Setting: 4444 Activate factory settings
123 Acknowledge fault message
Switching Frequency
switching frequency is dependent on the configuration.
Setting range: 2 kHz, 4 kHz, 8 kHz, 12 kHz, 16 kHz
Default : 2 kHz (Config 110)
8 kHz (Config 70x)
Min. Switching Frequency
Value the switching frequency is reduced automatically in the
case of thermal overload of the frequency inverter.
Setting range: 2 kHz, 4 kHz, 8 kHz, 12 kHz, 16 kHz
Default: 2 kHz (Config 110)
8 kHz (Config 70x)
Minimum Frequency
Enable inputs S1IND/ S7IND results in an acceleration of the
drive to the minimum frequency.
Setting: 0,00 Hz ... 999,99 Hz
Default: 0,00Hz
43
103 via digital input).
400 – The factory setting of the
401 – Defines the minimum
1)
418 – The start command via the
Quick Start Guide ACU-P