Adjusting The Reclining Position - CASUALPLAY Q-RETRAKTOR SAFE TECH FIX II Instructions

• The headrest should be positioned so that the harness is at the height of the
child's shoulders or slightly above. (fig.2).
• Adjust the knob on the headrest on the back of the seat to set the position
(Fig. 3).
How to use the buckle
• To open the buckle, press the red button (fig.4).
• To fasten the buckle, put the two clasps together and insert them into the
buckle (fig.5).

ADJUSTING THE RECLINING POSITION

• The reclining position of the child seat can be adjusted using the button
found on the lower part of the seat (fig.6).
• Hold the button pressed down until reaching the required position, a click
will indicate the different reclining positions.
FITTING THE INLET SOCKETS
NOTE: If your vehicle already has these inlet sockets there is no need to
fit them.
• Place the inlet sockets in front of both isofix anchor points, which are found
between the seat and the backrest (fig.7).
FITTING THE CHILD SEAT IN THE VEHICLE AS A GROUP 1 SEAT (ISOFIX +
TOP TETHER)
• Fit the inlet sockets. Consult the section explaining how to fit them if
necessary.
• Position the child seat on the vehicle seat facing forwards.
• Extract the isofix connectors using the front button. Pull the button and turn
it to the right (fig.8).
• Press the safety seat against the vehicle seat (fig.9) until both isofix
connectors are fastened into the seat anchor points. It will click when
correctly fastened (fig.10), and a green signal will appear on each connector
(fig.11).
• Adjust the inclination of the seat. To do this consult the section referring to
adjusting the reclining position.
• Using the central button, adjust the chassis of the safety seat until it touches
the backrest of the vehicle seat. Pull the button and turn it to the left (fig.12).
• Clip the karabiner of the Top Tether (on the adjuster side) into the ring on the
rear part of the backrest (fig.13), and connect the other end to the vehicle
anchor point. (fig.14).
NOTE: consult your vehicle instruction manual to locate the Top Tether ring.
29