CASUALPLAY Q-RETRAKTOR SAFE TECH FIX II Instructions página 30

• Tighten the Top Tether until the red tab on the tension adjuster disappears
(fig.15-16).
• Unfasten the harness buckle.
• Seat the child in the child car seat.
• Adjust the headrest.
• Extract the harness straps by pulling the top part while at the same time
pulling the clasps and passing the straps over the child's shoulders.
• Fasten the safety buckle by joining the two clasps and inserting them into
the buckle.
• The Q-RETRAKTOR FIX II harness is fitted with an automatic wind up
system that adjusts the straps to fit the child's body.
• Lastly, make sure that the harness fits the child's body correctly, and if
necessary, pull the abdominal belt a bit to eliminate any loose gaps.
NOTE: The Q-RETRAKTOR FIX II is fitted with an automatic wind up system,
the same as the vehicle seat belt, which will lock the harness straps in the
event of sharp braking or an accident.
REMOVING THE CHILD SEAT AS A GROUP 1 SEAT (ISOFIX + TOP
TETHER)
• Unfasten the safety harness and take the child out of the car seat.
• Unfasten the top tether by loosening the adjuster (fig.17) and unhooking
both karabiners (fig.18).
• Release the two isofix connectors by pulling the front lever (coloured red)
(fig.19). They will click when released, and a red signal will appear on both
connectors (fig.20).
• Remove the child seat from the vehicle seat.
FITTING THE CHILD SEAT IN THE VEHICLE AS A GROUP 1 SEAT
(ISOFIX + SUPPORT BAR)
NOTE: The support leg is an optional accessory that is sold separately.
• Fit the inlet sockets. Consult the section explaining how to fit them if necessary.
• Position the child seat on the vehicle seat facing forwards.
• Extract the isofix connectors using the front button. Pull the button and turn
it to the right (fig.8).
• Press the safety seat against the vehicle seat (fig.9) until both isofix
connectors are fastened into the seat anchor points. It will click when
correctly fastened (fig.10), and a green signal will appear on each connector
(fig.11).
• Adjust the inclination of the seat. To do this consult the section referring to
adjusting the reclining position.
30