CASUALPLAY Q-RETRAKTOR SAFE TECH FIX II Instructions página 31

• Using the central button, adjust the chassis of the safety seat until it touches
the backrest of the vehicle seat. Pull the button and turn it to the left (fig.12).
• Take the two stoppers off the front part of the base (fig.21).
• Simultaneously press the two pivots found on the upper tubes (fig.22).
• Insert both tubes into the front slots. They will click when correctly fastened
(fig.23).
• To adjust the height of the support leg, pull the red button found on the bar
and pull the support foot until it touches the floor. Release the red part and
check that it has not got stuck between two locking positions (fig.24).
WARNING: In order to obtain the maximum support possible, place it in the
correct locking position.
WARNING: The support foot should not be in mid-air or resting on an object
(fig.25).
• Unfasten the harness buckle.
• Seat the child in the child car seat.
• Adjust the headrest.
• Extract the harness straps by pulling the top part while at the same time
pulling the clasps and passing the straps over the child's shoulders.
• Fasten the safety buckle by joining the two clasps and inserting them into
the buckle.
• The Q-RETRAKTOR FIX II harness is fitted with an automatic wind up
system that adjusts the straps to fit the child's body.
• Lastly, make sure that the harness fits the child's body correctly, and if
necessary, pull the abdominal belt a bit to eliminate any loose gaps.
REMOVING THE CHILD SEAT AS A GROUP 1 SEAT (ISOFIX + SUPPORT
BAR)
• Unfasten the safety harness and take the child out of the car seat.
• Remove the support leg from the child seat. Simultaneously press the two
buttons found on the upper part of the base and at the same time pull the
support leg (fig.26).
• Release the two isofix connectors by pulling the front lever (coloured red)
(fig.19). They will click when released, and a red signal will appear on both
connectors (fig.20).
• Remove the child seat from the vehicle seat.
WARNING: If the retractor gets blocked, unblock it by pulling the two chest
sections of the harness pressing on the metal plate where the harnesses are
joined.
HARNESS REMOVAL (CHANGE TO GROUP 2)
31