PROTECTION MODE: Short-circuit/Overload Protection: If the AC or DC
output is short-circuited or overloaded (- Load(s) power output is greater
than 150W), the unit will shut down power output to protect itself. Some
devices, such as refrigerator, ice maker or a laser printer may require a
surge power, the surge power could exceed 300W or even higher, this
could cause overload protection with this unit. Please remove the devices
and consult with the device manufacturers for more information.
ERROR CODES
Code
Corrective Action
E01/
(DC and Error flash at same time): DC Over-Current Protection.
E02
Remove DC electrical appliances and restart the unit.
(DC and Error flash at same time): DC Short-Circuit Protection.
E03
Remove electrical appliances and restart the unit.
(AC and Error flash at same time): AC Inverter Unconnected,
E05
or AC inverter is broken, contact customer support at 1 (855)
944-3571.
(AC and Error flash at same time):
AC Over-Load Protection: please remove some electrical
appliances to lower the power to less than 150W, and restart
AC output
AC Short-Circuit Protection: please settle the short circuit
faulty problem, and restart AC output
E06
Inverter Board Over-Temperature Protection: Check air vents
for blockage or remove some AC appliances and restart AC
output.
-AC Input Voltage Too Low: Charge the unit.
-AC Input Voltage Too High: if "Error" indicator continues to
blink, contact customer support at 1 (855) 944-3571.
Westinghouse Outdoor Power Equipment - 11