Product Overview; Wiring Overview - Lutron Energi Savr Node Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Energi Savr Node

Product overview

An Energi Savr Node with EcoSystem system consists of an Energi Savr Node (ESN) with EcoSystem unit, EcoSystem-compatible
ballasts, inputs, wallstations, and QS devices. The diagram on the previous page shows an example of control inputs that are part of a
system.
• ESN with EcoSystem units are powered by line voltage (Hot and Neutral).
• The ESN with EcoSystem unit has inputs for:
– 4 Lutron
daylight sensors (model: EC-DIR-WH)
®
– 4 Lutron occupant sensors (models: Lutron LOS series)
– 4 Lutron infrared (IR) receivers (models: EC-DIR-WH, EC-IR-WH, CC-4BRL-WH, CC-1BRL-WH)
– 1 contact closure input
– 1 emergency contact closure input (defaults to Emergency Mode in the absence of a contact closure across the input)
• The QS Link can have up to 100 zones and 100 QS devices.
• The ESN with EcoSystem unit counts as 1 QS device and 1-100 zones on the QS link (depending on system programming).
• A system can have a maximum of 100 wired or wireless daylight sensors, 100 wired or wireless occupancy sensors, and 100 wired
or wireless controllers (Pico
• The ESN with EcoSystem unit supplies up to 30 Power Draw Units (PDUs) for powering accessory QS devices and sensors/controls
wired to QS Sensor Modules (QSMs). Refer to accessory device documentation for power draw information.
Refer to the following step-by-step guide for proper ESN with EcoSystem unit installation.

Wiring overview

QS
Link
Lutron
2
|
®
with EcoSystem
TM
wireless controllers, EcoSystem wallstations, IR receivers, or QS wallstations).
®
Control
power
|
Installation Guide
®
Inputs
Energi Savr Node
EcoSystem
Digital Links
CCI
Emerg
Ethernet
Jack
Contact
(Programming
Closure
Only)
Inputs
with EcoSystem
Installation Guide
TM
®

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Qsn-1eco-sQsn-2eco-s

Tabla de contenido