Preparing For Operation - Stihl Smart Connector Manual De Instrucciones

tact with the skin or eyes, the skin or
eyes may be irritated.
► Avoid contact with the liquid.
► If skin contact occurs: Wash affec‐
ted areas of skin with plenty of
water and soap.
► If eye contact occurs: flush eyes
with plenty of water for at least
15 minutes. Consult a doctor.
■ If the button cell battery is swallowed,
serious injuries or death may result
within 2 hours due to internal burns
and perforation of the esophagus.
► Keep the battery and Smart
Connector out of the reach of
children and other unauthor‐
ized persons.
► Always close the Smart Con‐
nector's cover securely. If it
is not possible to close the
cover, remove the battery
and replace the Smart Con‐
nector.
► If the button cell battery is
swallowed: do not induce
vomiting. This could result in
the battery lodging in the
esophagus. Seek medical
advice immediately.
■ A battery which is believed to be
completely discharged may still pro‐
duce a dangerous short-circuit cur‐
rent or may leak. This may result in
serious injury to people and damage
to property.
► Comply with all the statutory dis‐
posal regulations. Dispose of dis‐
charged batteries immediately. Do
not dismantle them. Do not dispose
of them by burning.

Preparing for Operation

The Smart Connector can only be
attached to certain products. The Smart
Connector has to be attached at a par‐
ticular place, depending on the product.
0457-399-0007-B. VA1.E21.
The Smart Connector can be attached
as follows:
– via the adhesive tape on the back
– via the 2 screws and washers sup‐
plied
– via 2 cable ties
– via 2 aluminum blind rivets with a
diameter of 3 mm and of the appropri‐
ate length for the product concerned.
The holes should be pre-drilled from
the inside of the housing using a drill
with a diameter of 3.5 mm.
STIHL recommends having a STIHL
authorized dealer fasten it using the
screws supplied, cable ties or blind riv‐
ets.
If attaching the Smart Connector to a
third party product STIHL recommends
attaching the Smart Connector via the
adhesive tape on the back.
Running time detection requires an
alternating electromagnetic field at a dis‐
tance of approx. 10 cm. An alternating
electromagnetic field is generated by
electric motors or spark plugs.
The following steps should be carried
out in order to fit the Smart Connector:
► Download the App from the mobile
terminal app store and create an
account.
► Add products to the app and follow
the on-screen instructions.
► Using a cloth and an isopropanol-
based cleaner, clean the site descri‐
bed in the App where the Smart Con‐
nector is to be attached. The installa‐
tion site must be level, clean, dry and
free from grease.
► Attach the Smart Connector as
described in the App or under
https://connect.stihl.com/
► If gluing the Smart Connector in
place: Stick it on at room temperature
and press on firmly.
.
9