Using Stream Direct; Using The Sound Retriever; Better Sound Using Phase Control - Pioneer VSX-820 Manual De Instrucciones

05 Listening to your system

Using Stream Direct

Use the Stream Direct modes when you want
to hear the truest possible reproduction of a
source. All unnecessary signal processing is
bypassed.
AUTO/
DIRECT
• While listening to a source, press AUTO/
DIRECT to select Stream Direct mode.
• AUTO SURROUND – See Auto playback on
page 33.
• DIRECT – Sources are heard according to
the settings made in the Surround Setup
(speaker setting, channel level, speaker
distance), as well as with dual mono
1
settings. You will hear sources according
to the number of channels in the signal.
• PURE DIRECT – Analog and PCM sources
are heard without any digital processing.

Using the Sound Retriever

When audio data is removed during the
compression process, sound quality often
suffers from an uneven sound image. The
Sound Retriever feature employs new DSP
technology that helps bring CD quality sound
back to compressed 2-channel audio by
restoring sound pressure and smoothing
jagged artifacts left over after compression.
RECEIVER
SLEEP SOURCE
RECEIVER
INPUT SELECT
• Press RECEIVER
to switch the sound retriever on or off.
Note
1 In the DIRECT mode, Phase Control, Acoustic Calibration EQ, Sound Delay, Auto Delay, LFE Attenuate and Center image
functions are available.
2 The Sound Retriever is only applicable to 2-channel sources.
36
En
STEREO/ BD MENU
A.L.C. STANDARD ADV SURR
HDD DVD VCR
1 2 3
TV
S.RETRIEVER SB CH CH SELECT
CONTROL
4 5 6
MIDNIGHT SPEAKERS LEV
7 8 9
INPUT
DIMMER LEV
, then press S.RETRIEVER

Better sound using Phase Control

This receiver's Phase Control feature uses
phase correction measures to make sure your
sound source arrives at the listening position in
phase, preventing unwanted distortion and/or
coloring of the sound (see illustration below).
During multichannel playback, LFE (Low-
Frequency Effects) signals as well as low-
frequency signals in each channel are
assigned to the subwoofer or other the
subwoofer and the most appropriate speaker.
At least in theory, however, this type of
processing involves a group delay that varies
with frequency, resulting in phase distortion
where the low-frequency sound is delayed or
muffled by the conflict with other channels.
With the Phase Control mode switched on, this
receiver can reproduce powerful bass sound
without deteriorating the quality of the original
sound (see illustration below).
P
H
A
S
E
C
O
N
T
R
O
L
Sound
O source
F
F
P
H
A
S
E
C
2
O
N
T
R
O
Sound
L
DISP
source
O
EQ
N
CH
PHASE
CH
SHIFT
Front speaker Listening
position
Subwoofer
Front speaker
Listening
position
Subwoofer
?