Maintenance And Care - Flex LW 1202 SN Instrucciones De Funcionamiento Originales

Switch on and off
LW 1202 N/~SN, LW 802 VR/~S
Brief operation without engaged switch
rocker
 Press and hold down the starting lockout.
 Press the switch and release the switch
interlock.
 To switch off, release the switch.
Continuous operation with engaged
switch rocker
CAUTION!
Following a power failure, the switched-on
machine will start running again.
 First press and hold down the starting
lockout and then the switch.
 To lock into position, hold down the
locking button and release the switch.
Release the starting lockout.
 To switch off, briefly press and release
the switch.
Speed preselection
(LW 802 VR/~S only)
To set the operating speed, move the dial to
the required value.
Setting
1
2
3
4
5
6
Operating instructions
NOTE
When the stone grinder is switched off,
the grinding tool continues running briefly.
 Attach sanding tool.
 Connect machine to the power supply.
 Connect the water.
 If required, adjust speed to the task
(LW 802 VR/~S only).
 Switch on the machine.
 Open shut-off valve on the water
connection.
 Applying light pressure, place the
grinding tool on the material to be
processed. Excessive pressure will
increase the wear on the grinding tool
and impair the grinding result.
20
–1
Speed (min )
800
1100
1400
1700
2000
2400
LW 1202 N/~SN / LW 1503/~S / LW 802 VR/~S

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
 Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration
of use.
 Regularly blow out the housing interior
and motor with dry compressed air.
Carbon brushes
The electric power tool features cut-off
carbon brushes. When the cut-off carbon
brushes reach their wear limit, the electric
power tool switches off automatically.
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, in particular grinding
tools, see the manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com