Maintenance And Care - Flex LDC 1709 FR Manual Del Usuario

7. Increase the pressure to bring the sanding
pad into contact with the work surface. In
doing so, slew the renovation sander with
overlapping movements.
8. LDC 1709 FR/LDC 1509 FR:
Sanding in corners:
– Switch off the power tool and wait until
the sanding tool has come to a standstill.
– Pull out pivoted edge segment and swivel
to left.
– Switch on power tool again.
9. After work, switch off the electric power
tool and pull out the mains plug.
22
LDC 1709 FR/LD 1709 FR/LDC 1509 FR
Brush ring (LDC 1709 FR/
LDC 1509 FR)
The guard features a brush ring. This ring has
two functions:
– As the ring projects above the surface of the
sanding pad, it is the ring which comes into
contact with the work surface first.
As a result, the sanding pad is brought
parallel to the work surface before the
sanding tool comes into contact with the
work surface. This avoids a sickle-shaped
depression caused by the edge of the
sanding pad.
– The ring retains the dust until it is extracted
by the dust extractor.
If the brush ring is damaged or excessively
worn, it should be replaced. A replacement
brush set (order no. 348.422) is available
from any FLEX-customer service centre.
Rubber extraction ring (LD 1709 FR)
If the rubber extraction ring is damaged
or excessively worn, it should be replaced.
It is available under order no. 257.246 from
any FLEX customer service centre.

Maintenance and care

t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK=
Cleaning
t^okfkd>
aç åçí=ìëÉ=ï~íÉê=çê=äáèìáÇ=ÇÉíÉêÖÉåíëK
 Regularly blow out the housing interior
and motor with dry compressed air.
 Clean the guard and pivoted edge segment
using dry compressed air.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
klqb
aìêáåÖ=íÜÉ=ï~êê~åíó=éÉêáçÇ=Çç=åçí=äççëÉå=
íÜÉ ëÅêÉïë=çå=íÜÉ=ãçíçê=ÜçìëáåÖK=
kçåJÅçãéäá~åÅÉ=ïáää=ÇÉÉã=íÜÉ=Öì~ê~åíÉÉ=
çÄäáÖ~íáçåë=çÑ=íÜÉ=ã~åìÑ~ÅíìêÉê=åìää=~åÇ=îçáÇK