Vacuum Sealer Canisters - Weston Pro-3500 Instrucciones

VACUUM SEALER CANISTERS

Vacuum canisters may
be used with the Vacuum
Sealer (Sold Separately).
Vacuum canisters come
with their own hose.
1. Attach the Vacuum Sealer
to the power supply.
2. Press the Power Button
on the Control Panel to turn
the Vacuum Sealer "ON".
The Power Indicator will
turn green and the Internal
Cooling Fan will run.
3. Insert one end of the
accessory hose into the
Accessory Port on the
Vacuum Sealer.
4. Insert the other end of the
accessory hose into the port
on the lid of the canister.
5. Fill the canister with
the product to be vacuum
sealed.
6. Turn the knob/dial on the
canister to the seal position.
7. Press the Canister Button. This will engage the Vacuum Pump.The
appliance will stop automatically when the seal process is complete.
8. Gently remove the accessory hose from both the canister and the Vacuum
Sealer. Wait at least 30 seconds before vacuuming another canister to avoid
overheating the unit. Be careful not to turn the knob/dial of the canister to the open
position.
9. To test vacuum, gently tug on the canister lid. The lid should not move.
10. To release the vacuum and open the canister, turn the knob/dial on the
canister to the open position.
11. Press the Power Button on the Control Panel to turn the Vacuum Sealer
"OFF".
12. Disconnect the Vacuum Sealer from the power supply.
14
(SOLD SEPARATELY)
270mm x 80mm Permanent Plastic Label
Accessory Hose
(sold separately,
with canister)
Accessory
Port
Canister
(sold separately)
Canister button