Control Buttons - Weston Pro-3500 Instrucciones

CONTROL BUTTONS

. Power: After plugging the Vacuum Sealer into the power supply and the
appliance, the Power Indicator Light will turn red. Once you press this button,
the Power Indicator Light will turn green, indicating that the machine is on.
. Full Vacuum: This operation will fully vacuum and seal the bag
automatically. Once you press this button, it will illuminate light blue. Vacuum
Time will change to 00 and Seal Time will show the last seal time setting (3 for
first use). Vacuum Time will count up from 00 until the bag is fully vacuumed.
. Vacuum Time: The Vacuum Time button adjusts the number of seconds
that the pump will stay engaged. Once you press this button, it will illuminate
dark blue and a number will display in the Vacuum Monitor, indicating that
vacuum time can now be adjusted using the +/- buttons. The light will go off
once the vacuum time is set.
. Seal Time: The Seal Time button adjusts the number of seconds that the
seal bar will engage in any Vacuum Operation (Full Vacuum, custom Vacuum
Time or Pulse). Once you press this button, it will illuminate dark blue and a
number will display in the Seal Monitor, indicating that the seal time can now
be adjusted using the +/- buttons. The light will go off once the seal time is set.
. +/- : Once either the Seal Time or Vacuum Time button has been pushed
and is illuminated dark blue, this will adjust the number of seconds for either.
. Vacuum Time Monitor: The numeric LED Vacuum Monitor indicates
the number of seconds that the vacuum pump is engaged. When in Full
Vacuum mode, this counts up from 00 until the bag is fully vacuumed. When
customizing vacuum time, the vacuum time will display at your chosen setting
and count down after you have pressed Start.
. Seal Time Monitor: The numeric LED Seal Monitor indicates the number of
seconds the seal bar is activated. This counts down from the set seal time.
. Manual Seal: This button will start the seal process at any time.
. Pulse: Be sure to hold the lid down when pressing this button. This button
will allow you to manually control the vacuum pump.
. Canister: Use this button to remove air from a canister attached to the port.
. Start: Press to begin the vacuum cycle (after selecting Full Vacuum or after
customizing the Vacuum Time).
. Cancel: Press at any time to end vacuum cycle.
270mm x 80mm Permanent Plastic Label
9