Replacing The Fuse - Weston Pro-3500 Instrucciones

REPLACING THE FUSE

If the Vacuum Sealer does not operate when it is plugged in and turned on, try
any or all of the following:
1. Make sure the Fuse is not blown. The Fuse is located on the right side of the
unit directly above the Power Cord Port. Turn "OFF" and unplug the Vacuum
Sealer. Twist off and remove the Fuse Cap. Remove and check the Fuse. The
thin metal band in the center of the Fuse should be clean and unbroken. If it is
burned and/or broken, replace it with a new Fuse (20 Amp). Replace the Fuse
Cap.
2. Make sure the Connector at the end of the Power Cord is plugged completely
into the Power Cord Port.
3. Make sure the Power Cord is not damaged. DO NOT use a damaged Power
Cord. Call the Customer Service line for information on part replacement.
4. Try connecting the Power Cord Plug to another electrical outlet.
2
18