Operating From The Remote Control - DeLonghi AN Serie Instrucciones De Uso

OPERATING FROM THE REMOTE CONTROL

USING THE REMOTE CONTROL
• Point the remote control at the receiver (A11) on the air
conditioner. The remote control must be no more than 16
ft (5 metres) away from the appliance (without obstacles
between the remote control and the receiver).
• The remote control must be handled with extreme care. Do
not drop it or expose it to direct sunlight or sources of heat.
MAX 5 metres
NOTE: The remote control can be safely stored in the appropiate
compartment A12 (see gure).
DESCRIPTION OF THE REMOTE CONTROL D
D1) ON/STAND-BY button
D2) Increase/decrease temperature/programmed operation
D3) "MODE" selection button
D4) Fan speed selection button (
D5) REAL FEEL selection button
D6) WHISPER COOL selection button
D7) Switch button °C/°F
D8) TIMER button
D1
D3
D4
INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control;
• Replace the old batteries with two new R03 "AAA" 1.5V bat-
teries, inserting them correctly (see the instructions inside
the battery compartment);
• Replace the cover.
MAX 16 ft
)
D2
D8
D7
D5 D6
If the remote control unit is replaced or discarded, the batteries
must be removed and disposed of in accordance with current
legislation as they are harmful to the environment. Do not mix
old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in re.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.
TURNING THE APPLIANCE ON
• Plug into the outlet.
• Press the button (D1) (when turned on, the air con-
ditioner starts operating in the same mode as when it was
turned o ) .
• To switch the appliance o , press button (D1)
remove the plug.
NOTE: Never switch the appliance o by removing the plug.
Always switch it o by pushing on the
waiting few minutes before removing the plug. Only in this
way the appliance will perform the standard checkings.
FUNCTIONS SELECTION
The controls on the remote control are the same as those on the
control panel of the appliance (C). You should therefore refer to
the instructions in the chapter "OPERATING FROM THE CON
TROL PANEL" to select the desired functions. Press button D7,
to switch the temperature display from °C to °F and vice versa.
Note:
• This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residen-
tial installation.
• This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit di er-
ent from that to which the receiver is connected.
10
, then
button and