DeLonghi AN Serie Instrucciones De Uso página 5

INTRODUCTION
Thank you for choosing a De'Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.
DESCRIPTION
Description of the appliance (see page 3 - A)
A1 air outlet grille
A2 control panel
A3 handles
A4 castor wheels
A5 BioSilver lter
A6 air intake grille
A7 air exhaust hose housing
A8 air intake grille
A9 power cable
A10 drainage hose with 2 caps
A11 remote control signal receiver
A12 remote control compartment
Descrizione of the accessories (see page 3 - B)
B1 wall ange with cap
B2 air exhaust hose
B3 hose adaptor
B4 accessory for wall mounting
B5 window bracket with pins
B6 additional window bracket
B7 window outlet
B8 remote control
B9 end of season dust cover (*not on all models)
B10 end of season accessories bag (*not on all models)
Electrical connection
Before plugging the appliance into the outlet, check that:
• The outlet's power supply corresponds to the value indi-
cated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the appli-
ance;
• The outlet is a 3-hole grounded outlet
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a quali ed professional only.
The instructions below will enable you to prepare your air con-
ditioner for operation as e ciently as possible. Before use, make
sure the air intake and outlet grilles are unobstructed.
USE
NOTE:
This appliance is provided with an auto-evaporation
feature for condensate removal during cooling and de-
humidi ng modes.
AIR CONDITIONING WITH INSTALLATION
For optimal results set-up your appliance in this way:
• Screw the hose adaptor B3 to the hose's end B2.
• Fit the air exhaust hose B2 in the housing at the back of the
appliance. Insert it as shown in gure 1.
1
• Respect the distances given in gure 2.
. If this is not
2
Proceed as follows:
• Drill a hole ø 5,25 inches (134 mm) in an outside wall or
through a window pane. Respect the dimensions and
height of the hole given in gure 3 and 4.
5
min. 11,8 in
min. 30cm
min. 11,8 in
min. 30cm