Foppapedretti MYO TRONIC Manual De Instrucciones página 30

WARNING: Before use, lift the seat to check that it has been secured correctly to the chassis.
Removing the seat (fig.16): Press the front button of the seat removal lever and keeping it pressed,
move the release lever towards the left to release the seat from the chassis.
FITTING THE HOOD
Fitting the hood (fig.17, 18): Insert the hood supports in their slots on both sides of the backrest.
Fasten the press fasteners of the hood behind the backrest (fig. 18).
Removing the hood (fig. 18, 19): Undo the hood press fasteners on the backrest, press the release
buttons near the mark on the outside of the seat and remove the hood by pulling it upwards.
FITTING THE FOOTMUFF
Fitting the footmuff (fig. 20): Insert the lower part of the footmuff on the seat of the chassis.
Secure the footmuff to the chassis of the pushchair using the press fasteners.
FITTING THE PUSHCHAIR RAINCOVER
Fitting the rain cover (fig.21): Open the zip on the front side of the rain cover and place it over
the hood. Insert the front part, with the elastic edging, under the footrest.
OPENING THE PUSHCHAIR (fig.22, 23, 24, 25, 26)
Press lever "A", in the direction shown by the arrow, to release the "fastening hook".
Lift the handle upwards, folding it backwards to open out the chassis. A click will show that it has
been opened out fully. Lift the handle as shown in figure 24.
Chassis opened out correctly fig.25
WARNING: make sure the Stroller is locked in the open position.
Fasten the seat, see the paragraph "Fitting the seat".
Fasten the protective bumper bar, see the paragraph "Fitting the bumper bar".
Fit the hood, see the paragraph "Fitting the hood".
WARNING: Before use, pull the seat upwards to check that it has been fastened correctly to the
chassis (fig.26).
SWIEL WHEELS
The stroller has swiel/fixed front wheels.
Swiel front wheels (fig. 27): to switch the front wheels to swielv mode, press the button.
Fixed front wheels (fig.28): Lift the locking lever on both of the front wheels and push the
pushchair forwards to operate the wheel lock.
ASSEMBLY
USE
MYO TRONIC 30
GB