Switching Off; Recharging The Battery - Foppapedretti MYO TRONIC Manual De Instrucciones

GB
USE
Notes of advice:
1. When the electric function is not in use, we recommend turning the accelerator handle to
position 0.
2. When the electric motor of the pushchair is started, it is advisable to push the pushchair slowly
forwards, to turn the accelerator handle to the low speed position and press both the buttons to
start the motor. This is to prevent starting off at high speed which could frighten baby. If necessary,
then increase the speed by turning the accelerator handle downwards.
3. When using the pushchair do not push it at high speed, for example when running, to prevent
damaging the motor.
4. If the pushchair is run electrically for a long time, it is normal that the motor cover heats up.
5. When encountering tight bends, release one of the buttons to stop the electric motor. Push the
pushchair manually around the bend. Once past the bend, press both buttons to start the electric
motor again.
WARNING: Do not touch the motor or the cover to avoid the risk of burning the skin due to the
high temperatures.

SWITCHING OFF

Release one or both of the power buttons to switch the electric motor off.
Important: Always turn the accelerator handle back to position 0 (fig. 11 pag. 10).
Important: Always operate the parking brake when the pushchair is not in use or not being
supervised (fig. 12 pag. 10).
LED power indicators
The battery charge is indicated by the lit LEDS.
When all the "LED" indicators are on (red and green), it means that the battery is fully charged.
The battery charge gets lower as the green LEDS go out.
If only the red LEDS are on, the battery needs to be recharged.
WRIST STRAP
When the battery operated function is used, it is advisable to use the wrist strap, placing it over
your hand, for greater safety.

RECHARGING THE BATTERY

The battery can be recharged both when it is fitted on the chassis and when it has been removed.
To remove the battery from the chassis, press buttons (A) and release it.
Lift the cover of the recharge socket.
Insert the battery charger connector to the battery recharge socket.
Connect the plug of the battery charger to an AC 220V mains power line.
MYO TRONIC 34