Cleaning; Maintenance; Troubleshooting - VOSS.farming FS10 Instrucciones De Operación

11

CLEANING

NOTE
► Do not use aggressive solvents/detergents, brushes, sharp objects or similar
for cleaning, as they may damage the surface.
► Do not immerse the device in water or other liquids. This may otherwise
cause a short circuit.
Use a damp cloth to clean the device if it becomes dirty.
12

MAINTENANCE

The device is low maintenance. You should nevertheless perform regular visual
inspections. Check the device for damage prior to each use.
NOTE
Do not use the device if it is visibly damaged.
13

TROUBLESHOOTING

NOTE
► Never open the housing and do not perform repairs by yourself. Contact
Service in case of repairs.
► Do not change or modify the device for unintended purposes. Exclusively use
original spare parts and accessories that are approved by the manufacturer.
Contact the seller if the device malfunctions or is found to be defective in any other
way, even after following the suggested solutions below. You will find the contact
details in section 18.
Error/problem
Device does not pair
Device does not respond
to the magnet
30
INSTRUCTION MANUAL VOSS.FARMING FENCE SENSOR FS10
Solution
There are too many interference signals or the
connection between the devices you wish to pair is too
weak. Place the devices you wish to pair close to each
other and in an area without interference signals.
Check the battery charge and replace the batteries if
necessary.
41645 | 11 | 2020 | V1