Operating Instructions; Attaching The Auxiliary Handle; Inserting/Replacing The Battery - Flex PE 150 18.0-EC Instrucciones De Funcionamiento Originales

Operating instructions

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack the polisher and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Attaching the auxiliary handle

The auxiliary handle can be attached
to improve handling of the polisher.
To do this, remove the handle cover
fastening screw from the side on which the
handle is to be attached.
When removing the handle, put back
the screw which was removed beforehand.
20

Inserting/replacing the battery

Press the charged battery into the power

tool until it clicks into place.
To remove, press the release button (1.)

and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
Press the button to check the state of

charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
PE 150 18.0-EC