Operating Instructions - Flex FS 3403 VRG Manual De Instrucciones

Renovation milling machine FS 3403 VRG
n Before using the power tool, check that
the tools have been fitted and attached
correctly. Switch on the machine at no
load for 30 seconds!
Interrupt the test run immediately if
violent vibrations occur or other damage
is established. Check the machine to
determine the cause.
n When operating the renovation milling
machine, connect it to a dust extractor.
The extraction system must be
authorised to extract stone dust.
An authorised special extractor must be
used to extract particularly harmful,
carcinogenic, dry dust.
n Do not grind or cut materials which
release hazardous substances
(e.g. asbestos).
n Keep hands away from rotating tools.
n Switch on the renovation milling
machine before guiding it towards
the workpiece.
n Do not load the renovation milling
machine to such an extent that it
comes to a standstill.
n Before putting down the renovation
milling machine, switch it off and wait
until it comes to a standstill.
n If power tools are used outdoors or are
exposed to excessive amounts of metal
dust, connect them via a residual-
current-operated circuit-breaker
(tripping current maximum 30 mA).
n Use only extension cables permitted for
outdoor use.
n Identify the power tool with stickers only.
Do not drill any holes into the housing.
Damage to property!
n The mains voltage and the voltage
specifications on the rating plate (4)
must correspond.
n Do not press the spindle lock (2) until the
grinding tool stops.

Operating instructions

Danger!
Before carrying out any work on the
renovation milling machine, pull out the
mains plug.
Before switching on the angle
grinder
Unpack the renovation milling machine
and check that no parts are missing or
damaged.
Attaching the bail handle
1. Push the bail handle (1) over the gear
head, ensuring that the finger recess
is face down.
2. Attach bail handle with the 2 enclosed
screws and Allen key.
15