Magnet Installation - Husky 28WC01BP-THD Manual Del Operador

LOCK INSTALLATION
Items Needed:
KK - Single Bitted Lock (Qty: 1)
Process:
• Hold lock (KK) in hand and insert key into lock.
• Hold lock (KK) securely with your hand and turn the
key to see which way the cam moves. The cam should
be pointing down when in the locked position and to
the right when in the unlocked position.
• Remove the key.
• Remove mounting nut or clip from lock (KK).
• Carefully push the lock thru the hole in the door, lining
up the flats on the threaded rod with the flats in the
door. Make sure the end of the cam points down, or to
the right (when looking from the front).
• Secure with lock nut or clip and test to be sure of
smooth operation.
Figure 10
Figure 10.1
Clip style lock.
Nut style lock.
7

MAGNET INSTALLATION

Items Needed:
HH - Magnet (Qty: 2)
Process:
• Place the magnet HH on the right door in the
locations noted.
• Make sure the adhesive backing is facing towards the
cabinet.
• Close the door to double check the Magnets are in the
correct positions.
• Open the door and remove the protective covering over
the adhesive on the back of the magnet.
• Close the door and press firmly on the front of the door to
seat magnets.
• The magnets will now be attached to the cabinet shell in
the correct location.
Figure 11
1.50-in
(3.81cm)
1.00-in
(2.54cm)
1.00-in
(2.54cm)
1.50-in
(3.81cm)