ATON HDR44 Manual Del Usuario página 19

HDR44 4x4 High Defi nition Video Router
IR Connections
Front Panel IR Emitter Connection
Insert the 3.5mm plug of an IR emitter into the designated IR Out port of the R44WP and place
the emitter on the IR receive window of an in-room video source or display.
SPDIF SPDIF
Y
L P
B
P
R
R
IR IN IN IR OUT OUT
R44WP
Figure 3-15: R44WP Front Panel IR Emitter Connection
Rear Panel IR Emitter Connection
Run a Cat-5 wire from the R44WP to the location of an in-room video source or AV Receiver.
Next, cut off the 3.5mm plug of an IR emitter and strip back the wire jacket to expose the wires.
Then, twist the bare ends of the IR emitter wires and splice them onto the appropriate conduc-
tors of the Cat-5 wire as shown in Figure 3-16
the screw terminals of the R44WP.
GND (Black)
IR (White Stripe)
ATON AIE2
IR Emitter
to Source
Figure 3-16: R44WP Rear IR Output
© 2008 • All rights reserved.
HD Video Display
IR Emitter
.
Finally, connect the correct Cat-5 conductors to
R44WP
Cat-5 Cable
GND (Brown)
IR (Blue/White)
GND
IR OUT
19